Hand Crafted Surfboards in Stock, Right Now!

shaped by Lou Dogg of Oceanside CA

6.2 Howitzer stringerless

carbon fiber to help keep the Dogs boards on top of two layers of 6 ounce cloth, un like the competitors who cheat and use 1 layer

carbon fiber

F4 Stringerless

F4 6;2 X 21 .2 X 2 5/8

F4 Phantom 4 Fin

F4 phantom 4 fin 6.8 X 22 X 3 3/8 for the bigger surfer or surfer that needs more meet under them

F4 6.8 tail width is 16.5 nose X 16 .5 tail

wide nose for easy wave catchin ability

wide nose for easy wave catchin ability

Rounded pins are so impressive especialy when the Dog wants to design a high flying pocket pulling stringerless or stringered shortboard, no thruster or shortboard can touch the performance of the howitzer

F4 twin with deep tail “V” designed by The Dog and Larry Bertlemann

Larry was persistant about deep “V” in tail

50cal, fins pushed back for good hard turns and single into double concave for easier turning This model is usually not epoxy

50 cal, you can visiulize the dual concave …and the fins are setter closer to the rails for utilizing every milimeter of your fins, on those tail tossing cut backs

The 50 Cal, Here is a shape by the Dog that relys alot on thruster type line carving instead of the rail to rail like the cobra, its geared for bigger wave / reef breaks , Also fun in small sand bars 7’2 to 8’2

50 Cal, The tail section is build more so for down the line hard carving and great for getting slotted, especialy for bigger surfers who consider this to be a short board…

The Cobra, 7’6 x 22 x 2 5/8 4 double wing squash 4 fin

18 inch nose gives the surfer the added advantage of catching all the waves plus a bit of nose riding abilitys with out sacraficing manuverability

Lou Dog has made over 2,300.00 Cobra’s since the first one in 2009,

This Gatlin gun comes in sizes 5’6 to 6’10

The concave in this board is reverse ‘v’ into single into double concave which pushes water through the bottom of your board

this 6’8 is shaped for a goofie foot surfer, as the back side rear railes edge is sharper and goes up 2 inches further then the opposite rail, Lou Dog really takes his shaping more serious then any other shaper,

Can you believe the serious concave in this boards trail. design

6’8 Gatling gun, Here is one of the sweetest thruster you can image, sharp hard turns, with double 6 ounce glass on deck to prevent big preassure dings from air moves

6 inch wide squash tail, slight hipps 12 inches up, which helps the board turn like a knife,

4 fin stringerless

concaved dual double barrel concave

F4 phantom 4 fin

same deep concave

F4 6.8 bottom

F4 6.8 tail concave

The tomahawk; This The 44 magnum or the Magnum; This board comes in 7’10 to 8 ’10 it has such deep concave that it is a special order, it has a trihaul construction, The dog design in 1988 to help high performance the longboard or the interseptor mo

The 44 Magnum; tri haul 7’10 to 8; 10 usually a custom order instead of finding it in Lou Dogs wave weapon surfshop but you can get lucky and find that Lou made 5 or 6 for the rack

Here is another 9 ft 4 inch SUP with custom material inlay on the deck, Lou Dogs art on Bottom board weighs under 15 pounds

New Epoxy Retro Fish F4 Phantom

shaped by LouDogg

The epoxy retro fish surfboard is one of the most unique designs when it comes to “wave catch-ability” and durability!

This retro fish board maintains the width of a Mini-longboard, but is much smaller in length. Get the best of both worlds by this combination of design. Float easily and maintain your stability with the width of the fish. Turn quickly and easily with the twin fin set up designed to channel water off the rails allowing you to generate speed and make some killer cut-backs.

New Epoxy Retro Fish F4 Phantom

shaped by LouDogg

New Epoxy Retro Fish F4 Phantom

shaped by LouDogg

The epoxy retro fish surfboard is one of the most unique designs when it comes to “wave catch-ability” and durability!

This retro fish board maintains the width of a Mini-longboard, but is much smaller in length. Get the best of both worlds by this combination of design. Float easily and maintain your stability with the width of the fish. Turn quickly and easily with the twin fin set up designed to channel water off the rails allowing you to generate speed and make some killer cut-backs.

Add new Super Fusion epoxy construction and you cannot pass up this board. 10% Lighter… 30% Stronger… Superior in almost every way to traditional construction.

The epoxy retro fish surfboard is perfect for the intermediate surfer, or someone who wants to move from a long board down to a short board.

2 fin $390

4 fin $425

sizes 5′6 – 6′10

The Grunt

The Grunt

Single concaved bottom is one of the most sought after thrusters. Triple winged swallow tail. It has the same feel and build as the fish but with a little more “hold”. This board also features medium rocker, low rails and a slight Vee into moderate roll on the bottom with a single concave through a wide split tail but has double breaks for a narrower tail block.

Great Board for beginners to advanced surfers. This surfboard is fun on small to head high waves.

3 fin $425

sizes 5′6 – 6′10

Epoxy Noserider _ Interceptor

Epoxy Noserider _ Interceptor_ Rips like a fish.

So you wanna ride the nose? This model is specifically made for nose riding in small to mid range surf. If features an 18″ nose with a deep nose concave running into a single concave bottom to adds lift with a double wing swallow tail design helps with projection out of the turns. For those less experienced surfers its got the extra volume to make for easy paddling and maximum wave count. The Interceptor Noserider is a performance longboard for any skill level.

single fin $459

sizes 5′6 – 6′10

Exterminator_ High Performance Long Board

Exterminator_ High Performance Long Board

For you experienced surfers and seasoned longboarders, you will feel confident and comfortable as you make sweeping turns down the line.

We are offering this model in our new Super Fusion epoxy construction featuring a double layer 6oz fiberglass cloth deck and double layer 4oz fiberglass bottom for tremendously increased strength while maintaining flex. The outer epoxy resin makes this construction near bulletproof.

single fin $459

sizes 5′6 – 6′10

Exterminator_ High Performance Long Board

Trestles Special_ High Performance Long Board

For you experienced surfers and seasoned longboarders, you will feel confident and comfortable as you make sweeping turns down the line.

We are offering this model in our new Super Fusion epoxy construction featuring a double layer 6oz fiberglass cloth deck and double layer 4oz fiberglass bottom for tremendously increased strength while maintaining flex. The outer epoxy resin makes this construction near bulletproof.

24 x 3 1/2

sizes 10′6

Kainalu_ High Performance Long Board

For you experienced surfers and seasoned longboarders, you will feel confident and comfortable as you make sweeping turns down the line.

We are offering this model in our new Super Fusion epoxy construction featuring a double layer 6oz fiberglass cloth deck and double layer 4oz fiberglass bottom for tremendously increased strength while maintaining flex. The outer epoxy resin makes this construction near bulletproof.

24 x 3 1/2

sizes 10′6

Kainalu White_ High Performance Long Board

For you experienced surfers and seasoned longboarders, you will feel confident and comfortable as you make sweeping turns down the line.

We are offering this model in our new Super Fusion epoxy construction featuring a double layer 6oz fiberglass cloth deck and double layer 4oz fiberglass bottom for tremendously increased strength while maintaining flex. The outer epoxy resin makes this construction near bulletproof.

24 x 3 1/2

sizes 10′6

Ace_ High Performance Long Board

For you experienced surfers and seasoned longboarders, you will feel confident and comfortable as you make sweeping turns down the line.

We are offering this model in our new Super Fusion epoxy construction featuring a double layer 6oz fiberglass cloth deck and double layer 4oz fiberglass bottom for tremendously increased strength while maintaining flex. The outer epoxy resin makes this construction near bulletproof.

24 x 3 1/2

sizes 10′6

Pink Angel _ High Performance Long Board

I can make this board any size you desire even make this a 6.10″. This board has quite a few different designs than other manufactures. It has more nose kick so it doesn’t pearl. There is a speed spot between your feet with double concave so it is faster. Its got softer rails with a slight chime in it. The fins are moved up to make this board turn like its a 7.2″ This is the ultimate easy nose rider!

epoxy

sizes 6′

Call

760 529-9961 Shop

760 809-6180

760 809-8642

All boards shown are in stock right now. Pricing

Pick yours up at; 1922 South Coast Highway, Oceanside CA 92054